STANDARDS

The Standards are available to suit any propping or access application economically. The Standards can be used for support or access as required.

SPECIFICATIONS

LEDGERS

Ledgers have identical forged Blade ends, with a minimum of projection to avoid damage. Ledgers are available in a range of standard sizes or can be made to special length if required.

SPECIFICATIONS

INTERMEDIATE TRANSOMS

The component is designed and available for use where distances between ledgers exceed the maximum permitted span of the scaffold boards.

SPECIFICATIONS

DECKING BEAMS

The light weight steel fabrication includes a 100mm wide top flange which eliminates the necessity for a plywood infill, so cutting down maintenance costs. Heavy duty pressings are fitted to the beam ends ensuring adequate protection against site abuse. These incorporate a tongue location for the drophead.

SPECIFICATIONS

INFILL BEAMS

The infill beams have been designed to be used with the Decking Beams to provide a support for plywood decking.
The infill beams come in 5 lengths to allow for flexibility of grid sizes to suit all types of slabs .

SPECIFICATIONS

ADJUSTABLE BASEJACK

The adjustable Base Jack is used at the bottom of the Standard to provide an additional maximum adjustment of 400 mm.

SPECIFICATIONS

UNIVERSAL JACK

The 57KN capacity galvanized Universal Screw Jack has an adjustment range of over 400 mm. It is manufactured from 38 mm outside diameter steel tube with a rolled square thread for fast trouble free operation. The Jack can be used either at the top or the bottom of the vertical standard. In each case the unthreaded portion is inserted into the Vertical so that the correct amount of the Jack always remains inside the Vertical for safety.

SPECIFICATIONS

ADJUSTABLE FORKHEAD

Falcon’s forkheads are for timber, steel or aluminum beam support. They are designed for use with single or double timbers of 75mm nominal width, and can be used with a universal jack for height adjustment.

SPECIFICATIONS

SPIGOT PIN WITH BOLTS & NUTS

Standards are connected end to end with internal spigots. A bolt is used to connect to the lower standard.

SPECIFICATIONS

DROPHEAD

Falcon’s quick action dropheads, supplied with nuts and bolts, are designed to fit standard props or adaptors for F-lock scaffolding. They allow panels and beams to be struck and reused after only three or four days, leaving the support in position for the remainder of the curing period of the concrete slab. The primary head remains in contact with the concrete, while the secondary head and its supporting wedge are released by a single hammer blow. The height of the drophead is 214mm. The striking distance allows the beams and panels to drop only 115mm for their safe removal, a marked improvement in terms of speed and safety when compared with other systems. The dropheads have a load carrying capacity of 40KN.

SPECIFICATIONS

S0CKET ADAPTOR

It serves as a connector for Drophead and Universal Jack

SPECIFICATIONS

BEAM BRACKET

Falcon’s beam brackets eliminate full height propping to beam formwork by locating into slab support verticals (as shown). The brackets accept standard jacks and forkheads.

SPECIFICATIONS

CANTILEVER FRAME

Falcon’s cantilever frames fix directly to the vertical at the node points. The frames accept universal jacks for carrying support.

SPECIFICATIONS

BEAM SHOE

Falcon’s beam shoes are a simple attachment allowing a 150mm x 100mm timber beam to be used for non-standard or special length beams. They nailed to the timber beams, allowing them to fit onto dropheads.

INFILL BEAM SHOE

A simple attachment allowing a 150mm x 100mm timber beam to be used for non-standards or special length beams.

SPECIFICATIONS

SPIGOT CONNECTOR (WITH WASHER)

Standards are connected end to end with internal spigots that are provided with washer stopper for faster installation.

SPECIFICATIONS